Operating the Equipment Locally
Page 3-16 Instruction Manual: TT1260 Standard Definition Professional Receiver/Decoder
ST.TM.E10100.1
3.7 Setting Up the Alarms (Menu #5)
Menu #5 allows a selection of Alarms to be edited.
Table 3.18: Setting up the Alarms
Step Action Result
1 Go to Menu #5.
Accesses the Alarms menu.
2 Scroll down to Menu #5.1 and edit the BIT
ERROR RATE range (9.9 E-1 to 1.0 E-8) and
status (NO ALARM, SET ALARM ONLY, SET
ALARM AND RELAY 1, SET ALARM AND
RELAY 2, SET ALARM AND RELAY 3, SET
ALARM AND RELAY 4, SET ALARM AND
RELAY 5, SET ALARM AND RELAY 6, SET
RELAY 1 ONLY, SET RELAY 2 ONLY, SET
RELAY 3 ONLY, SET RELAY 4 ONLY, SET
RELAY 5 ONLY, or SET RELAY 6 ONLY ).
Press SAVE.
Edits the BER alarms menu.
2 Scroll down to Menu #5.2 and edit the
TRANSPORT STREAM menu (NO ALARM,
SET ALARM ONLY, SET ALARM AND
RELAY 1 – 6, SET RELAY 1 – 6 ONLY).
Press SAVE.
Edits the Transport Stream alarms menu.
3 Scroll down to Menu #5.3 and edit the VIDEO
menu (NO ALARM, SET ALARM ONLY, SET
ALARM AND RELAY 1 – 6, SET RELAY 1 – 6
ONLY). Press SAVE.
Edits the Video alarms menu.
4 Scroll down to Menu #5.4 and edit the
AUDIO 1 menu (NO ALARM, SET ALARM
ONLY, SET ALARM AND RELAY 1 – 6, SET
RELAY 1 – 6 ONLY). Press SAVE.
Edits the Audio 1 alarms menu.
5 Scroll down to Menu #5.5 and edit the
AUDIO 2 menu (NO ALARM, SET ALARM
ONLY, SET ALARM AND RELAY 1 – 6, SET
RELAY 1 – 6 ONLY). Press SAVE.
Edits the Audio 2 alarms menu.
3.8 Setting Up System Parameters (Menu #6)
This menu gives access to the Setup Menu to set up and edit System
Parameters as well as the IRD Details menu (see Table 3.20).
Table 3.19: Setting Up a System
Step Action Result
1 Go to Menu #6.
Accesses the System menu.
2 Scroll down to Menu #6.1 and edit the
Operating Mode (FRONT PANEL, SERIAL
REMOTE or DIRECTOR NCP). Press SAVE.
Edits the Operating Mode menu.
3 Scroll down to Menu #6.1.1 and edit the LCD
Contrast (LOW, MEDIUM or HIGH). Press
SAVE.
Edits the LCD Contrast.
4 Scroll down to Menu #6.1.3 and edit the IP
Address. Press SAVE.
Edits the IP Address.