Filter
Top Products
Operating the Equipment Locally
Page 3-8 Instruction Manual: TT1260 Standard Definition Professional Receiver/Decoder
ST.TM.E10100.1
3.5 Setting Up the Input (Menu #2)
3.5.1 Satellite Receiver
Use Table 3.5 to step through the set up procedure of the Satellite
Receiver using Menu #2. The transmission parameters must be known
before starting.
Table 3.5: Setting Up the Satellite Receiver
Step Action Result
1 Go to Menu #2.2 and select SOURCE 1. The Receiver takes its signals from two sources. Set up both sources.
2 Scroll down to Menu #2.3. Enter the LNB
FREQUENCY then press SAVE.
This sets up the LNB frequency for the selected Source in MHz.
3 Scroll down to Menu #2.3.1. Enter the
SATELLITE FREQUENCY then press
SAVE.
This sets up the Satellite frequency for the selected Source in MHz.
4 Scroll down to Menu #2.3.2. Enter the
SYMBOL RATE then press SAVE.
Sets the symbol rate for the selected Source in megasymbols per
second.
5 Scroll down to Menu #2.3.3. Enter the
MODULATION and FEC RATES then
press SAVE.
This sets up the Modulation (QPSK, 8PSK, 16QAM) and FEC (1/2,
2/3, 3/4, 5/6, 7/8, 8/9) rates for the selected Source. The FEC
selection is limited to the valid values of the currently selected
modulation type.
6 Scroll down to Menu #2.3.4. Enter the
LNB POWER and VOLTAGE settings
then press SAVE.
Sets the LNB power for the selected Source (ON, OFF, BOOSTED).
BOOSTED provides 1V extra power over the ON setting. Also sets
the LNB voltage settings (18v – Horiz, 13v – Vert).
7 Scroll down to Menu #2.3.5. Enter the
LNB 22 KHz setting then press SAVE.
Enables or disables the LNB 22 kHz control tone for the selected
Source (On, Off).
8 Scroll down to Menu #2.3.6. Enter the
SEARCH RANGE then press SAVE.
This sets up the centre frequency Search Range for the selected
Source in KHz.
9 Scroll down to Menu #2.2 and select
SOURCE 2. Repeat steps 2 through 8.
3.5.2 Decoder
Table 3.6: Setting Up the Decoder
Step Action Result
1 Go to Menu #2.1 and select the required
input: 1, 2, or AUTO.
This sets the ASI input source for the TT1260. If AUTO is chosen,
ensure that the signal is only routed to one connector at a time.
2 Press SAVE to store the option.