Filter
Top Products
Installing the Equipment
Page 2-12 Instruction Manual: TT1260 Standard Definition Professional Receiver/Decoder
ST.TM.E10100.1
Frame Synchronisation
A BNC socket is used by the Decoder to frame
lock to an external video source. The frame
information is input as a composite synchronise
signal, with or without active video. The user can
offset the synchronisation to the video output by
±8 lines, with a resolution of 1 pixel. Lip sync
error introduced by the Receiver is in the range –
10ms to +30ms. This implies audio frame skip
and repeat.
The video and audio can be synchronised to an
analogue studio reference signal. This supports
both 625 and 525 frame locking.
This F Sync is activated through the Service menu
(#3). The specification for this connector is given
in Section B.4.4, Frame Sync Connector.
FRAME SYNC Hi-Z
Table 2.8: Frame Sync Hi-Z Connector
Item Specification
Connector type BNC 75 W socket
Connector designation FRAME SYNC Hi-Z
Pin: Centre Analogue Black and Burst Input
Shield Ground/Chassis
Impedance Last unit must be terminated with 75 W
Ethernet
The TT1260 has an Ethernet remote control port
for TANDBERG engineering debug purposes and
future functionality.
10/100 Base-T
Table 2.9: Ethernet Pin-outs
Item Specification
Connector type RJ-45 (100BaseT)
Connector designation 10/100Base-T
Pin-outs
(Unused pins not
connected)
Pin 1 ¾ Tx Out (+)
Pin 2 ¾ Tx Out (-)
Pin 3 ¾ Rx In (+)
Pin 6 ¾ Rx In (-)