Filter
Top Products
6.3. Basic Setting Operations
This section shows basic operating procedures for each setting item. Note, however, that the password setting
differs from those explained here. Refer to p. 40 for the password setting procedure.
Step 1. Press the Menu key with a pointed object.
[When the password has been set]
The password entry screen is displayed.
1-1. Enter the password (4 digits) using the numeric keypad.
1-2. Press the SET key.
If the password is correct, the menu screen appears.
[When the password has not been set]
The menu screen appears.
Step 2. Tilt the joystick up or down to select the setting
item.
Step 3. Press the SET key to confirm the setting item.
The current setting contents (if not set, the
factory-predetermined setting contents) are
displayed at the lower part of the LCD screen.
In this event, one character "1" of the setting
contents flashes. (The flashing character
differs depending on the content.)
Step 4. Tilt the joystick left or right to select the desired
setting content.
Tip
Pressing the Clear key before Step 4 is
completed will return the display to the screen
last shown (in Step 2) before the SET key was
pressed.
Step 5. Press the SET key to confirm the setting
contents.
The display returns to the screen (in Step 2) to
select the setting item.
Step 6. Repeat Steps 2 – 5 to continue to set other items.
Press the Menu key when returning to the normal screen after setting completion.
23
PASSWORD
1234
(Example)
4321
MENU
PASSWORD
SET
OPERAT I ON MODE
OPERAT I ON MODE
UP
DOWN
RIGHTLEFT
AUTO RETURN
(Example)
SET
AUTO RETURN
1.ON
Flashes
UP
DOWN
RIGHTLEFT
AUTO RETURN
1.ON 10S EC
(Example)
SET
AUTO RETURN
(Step. 2)