Filter
Top Products
"Initial screen" Setting Setting
1. FULL Enter the channel to be designated with the numeric keypad, and confirm
the setting with the SET key.
Note: This selection is set to "1" by the factory.
4. 4-SEG Tilt the joystick to the left or right to select "1 – 4," "5 – 8," "9 – 12," or "13 –
16" and confirm with the SET key.
Note: This selection is set to "1 – 4" by the factory.
5. 9-SEG Tilt the joystick to the left or right to select "1 – 9" or "10 – 16," and confirm
with the SET key.
Note: This selection is set to "1 – 9" by the factory.
6. 10-SEG Tilt the joystick to the left or right to select "1 – 8" or "9 – 16," and confirm
with the SET key.
Notes
• Make sure that this setting is the same as that of the connected switcher.
• This selection is set to "1 – 8" by the factory.
31
INITIAL CHANNEL
14
INITIAL CHANNEL
19
INITIAL CHANNEL
18
INITIAL CHANNEL
CHANNEL12 3
[Setting contents]
6.4.9. Channel designation
Sets the first channel (camera number) to be displayed after the power is turned ON.
Note
This channel setting can only be performed when one of the settings "1. FULL," "4. 4-SEG," "5. 9-SEG," or "6.
10-SEG" has been selected in the "Initial screen" setting. The Channel Designation item is not displayed on
the menu screen when another setting has been selected.
Step 1. Press the Menu key to display the menu screen.
Step 2. Tilt the joystick up or down to select "INITIAL CHANNEL," then confirm the selection with the SET key.
The setting corresponding to the Initial Screen setting is displayed on Line 2.
Step 3. Using the joystick and numeric keypad, select the setting depending on the "Initial screen" setting,
and confirm the selected setting with the SET key. (Refer to the table shown below.)
(10-segment split-screen
display)
(9-segment split-screen
display)
(4-segment split-screen
display)
(full screen)