Filter
Top Products
6.4.15. Alarm time
Sets the interval between alarm input and alarm reset.
Note
The Alarm Time can only be set when "1. EDGE" has been selected in the "Alarm signal" setting. This setting
item is not displayed on the menu screen when "2. LEVEL" has been selected.
Step 1. Press the Menu key to display the menu screen.
Step 2. Tilt the joystick up or down to select "ALARM TIME," and confirm the selection with the SET key.
The setting is displayed on Line 2.
Step 3. Tilt the joystick to the left or right to select one of the following settings, and confirm it with the SET key.
6.4.14. Alarm signal
Sets continuous alarm operations.
Step 1. Press the Menu key to display the menu screen.
Step 2. Tilt the joystick up or down to select "ALARM SIGNAL," and confirm the selection with the SET key.
The setting is displayed on Line 2.
Step 3. Tilt the joystick to the left or right to select either of the following settings, and confirm it with the
SET key.
35
ALARM S IGNAL
1.EDGE
ALARM T IME
3.20SEC
1. 10SEC (10 seconds) 6. 2MIN (2 minutes)
2. 15SEC (15 seconds) 7. 3MIN (3 minutes)
3. 20SEC (20 seconds) 8. 4MIN (4 minutes)
4. 30SEC (30 seconds) 9. 5MIN (5 minutes)
5. 1MIN (1 minute) 10. NO LIMIT (no time limit)
[Setting contents]
[Setting contents]
Note: This selection is set to "1. EDGE" by the factory.
Notes
• If "10. NO LIMIT" is selected, the alarm can only be reset when the Alarm Reset key on the unit's top panel
is pressed.
• This selection is set to "3. 20SEC" by the factory.
1. EDGE Terminates alarm operations when the time interval set in the "Alarm time" setting (next
item) passes or when an alarm reset signal is received.
2. LEVEL Terminates alarm operations when the alarm input terminal receives alarm end data. Also,
if "1. ON" has been selected in the "Camera alarm" setting, alarm operation will stop when
all alarm signals from the camera change from make to break data.