Filter
Top Products
22
EN
Copyright protection system
To play back the digital video images of a DVD via an
HDMI connection, it is necessary that both the player
and the display device (or an AV amplifier) support a
copyright protection system called HDCP (high-
bandwidth digital content protection system). HDCP is
copy protection technology that comprises data
encryption and authentication of the connected AV
device. This unit supports HDCP. Please read the
operating instructions of your display device (or AV
amplifier) for more information.
* HDMI: High Definition Multimedia Interface
Note
• Because HDMI is an evolving technology, it is
possible that some devices with an HDMI input may
not operate properly with this unit.
• When using an HDCP-incompatible display device,
the image will not be viewed properly.
• Among the devices that support HDMI, some
devices can control other devices via the HDMI
connector; however, this unit cannot be controlled by
another device via the HDMI connector.
• The audio signals from the HDMI connector
(including the sampling frequency, the number of
channels and bit length) may be limited by the
device that is connected.
• Among the monitors that support HDMI, some do
not support audio output (for example, projectors).
In connections with device such as this unit, audio
signals are not output from the HDMI output
connector.
• When this unit’s HDMI connector is connected to a
DVI-D compatible monitor (HDCP compatible) with
an HDMI-DVI conversion cable, the signals are
output in digital RGB.
• If the connected equipment is not compatible with
HDMI BITSTREAM, DTS sound will not be output.
• When the power failure occurs, or when you unplug
the unit, some problems in the HDMI setting might
occur.
Please check and set the HDMI setting again.
Connecting to an External Equipment
This unit has three input terminals which can be
selected using [INPUT SELECT F] on the remote
control, AV1 or AV2 on the rear panel and AV3 on the
front panel. Be sure that all the units are switched off
before making connections.
Recording from a DVD player, Satellite Box
or other Audio-Video equipment with a Scart
output socket (AV2)
Note
• When you record a TV programme from a Satellite
Box, you must connect a Scart cable to AV2
(DECODER). (See page 49.)
• When AV2 is connected, the signal from the AV2 will
be output automatically. If you want to monitor the
signal from other input, you must press [DISPLAY]
first. Then, select the desired input to monitor with
[INPUT SELECT F].
Recording from a camcorder or other
Audio-Video equipment with no Scart output
socket (AV3)
Connect to AUDIO / VIDEO input jacks on the front
panel using an RCA Audio/Video cables.
When connecting a DV-camcorder, use DV input jack
of AV4 (Front).
Note
• When connecting an external device of monaural
output to this unit, use AUDIO L jack of AV3.
HDMI OUT
AV output jack
(Scart)
Scart cable (not supplied)
AV2 (DECODER)
B
BING VCR HDD DVD
SELECT
REC
HDD/DVDSELECTSELECT
DVD
R
DVD
D
DVDHDD
AV3 (Front)
AUDIO OUT
Audio cable
(not supplied)
DV cable
(4-pin)
(not supplied)
DV OUT
Video cable
(not supplied)
VIDEO OUT
E3NG0FD_EN.book Page 22 Wednesday, January 30, 2008 10:37 AM