106 Administrator’s Guide
BMC Atrium Integration Engine 7.1.00
Debug logging settings
From the Data Exchanges Information window, you can now log various levels of
debug information.
X To enable debug logging
1 On the Data Exchanges Information window, click the Advance Settings tab.
The Debug Settings window appears.
Figure 6-1: Debug Settings window--Advance Settings tab
2
In the Enable Debug Logging field, click Yes.
3 In the Debug File Path, browse to select the location of the debug files.
If the Debug File Path field is blank and you have clicked Yes to enable debug
logging, then the log is written to the default debug path you specified during
installation of Integration Engine.
4 In the Debug File Creation area, do one of the following:
Click Create Backup to create new log files and write the contents of the
previous log files to the
<DataExchangeName>_<TimeStamp>.bak file.
Click Append To Existing to preserve the log files and their contents. New
information is appended to the existing file or is wrapped to the top of the file.
5 In the Max Debug Size field, type the maximum size (in bytes) for the log file.
NOTE
The log file size cannot be set to less than 4096 because that could be the length of
a single log line. When the log file reaches the maximum limit, depending upon the
Log-File Creation settings either the backup file is created or the new information
wraps to the top of the file, overwriting the old information.
