Filter
Top Products
4 Connections
The references a b c etc. mentioned below refer to the illu-
stration on page 10.
4.1 Mains power connection
The digital receiver should only be connected to the mains
power supply after it has been completely connected with all
other components in the system. This serves to avoid the
digital receiver or other components being damaged or
destroyed.
a When you have completed making all the connec-
tions, use the mains cable supplied to connect the
receiver to a mains power outlet 85-288 V/50-60 Hz.
4.2 External unit
4.2.1 Single operation
b Use a suitable coaxial cable to connect the LNC
input of the digital receiver to the LNC of your
external unit. Please also note Point 6 “Settings”.
4.2.2 Operation with an additional receiver in a sin-
gle-receiver installation
c If you wish to operate an additional unit in a single-
receiver installation (e.g. an analogue receiver or an
ADR receiver), you can connect the LNC input of the
additional receiver with the LNC output of the DVB
receiver by means of a suitable coaxial cable. In order
for the additional receiver to receive the satellite sig-
nal, your DVB receiver must remain in Standby mode
at all times. When the DVB receiver is switched on,
this will take over the priority control over the LNC.
4.3 Connection to a television set
When you have completed connecting your digital receiver to
the television set as described in this chapter, it may be
necessary to adjust the digital receiver to the television bro-
adcast standard of your TV set before proceeding with further
settings.
See also Point 6.3.5 (Video system).
4.3.1 On SCART cables
In order to enjoy the optimum picture quality you should con-
nect the digital receiver to your television set by means of a
SCART cable.
11
bed_anl_DVB13 CIP_englisch_q5.qxd 08.09.03 11:14 Seite 11