Filter
Top Products
2. Reminder
If your receiver is in normal operational mode, it will
switch to the pre-selected programme slot at the pre-
set time. In contrast to the VCR setting, the controls
remain fully functional, and the receiver will not be
switched off at the end of the programme.
Transferring data into memory
> When you have completed programming, press the
yellow function key Transfer to transfer the data
into memory.
If under Channel you have selected an encrypted
programme, or a programme that is blocked as per
8.1.6, you will first have to enter the PIN code before
the data can be transferred to memory.
7.15.2 Changing timer programming
> To change an existing timer setting, use the arrow
keys up/down to mark the setting. Press the yel-
low function key Change to move to the settings of
the marked timer. You can now effect the changes as
described in Point 7.15.1.
7.15.3 Deleting timer programming
> To delete an existing timer setting, use the arrow
keys up/down to mark the setting.
> Press the green function key Delete.
The message will be displayed:“Do you really want to
delete this timer?”
> Use the arrow keys right/left to mark Yes.
> To delete the timer entry, confirm by pressing OK.
> Press the TV/Radio key to return to normal opera-
tion.
Note!!!
Ensure that the standard time has been read into the recei-
ver. This will be shown on the display* when the unit is in
standby mode. If this is not the case, switch the receiver to a
major channel such as ZDF for approximately 30 seconds, to
read the current time automatically.
The time should now be shown on the display when the
receiver is set to standby mode.
39
* Only for receivers equipped with
this feature
bed_anl_DVB13 CIP_englisch_q5.qxd 08.09.03 11:14 Seite 39