Filter
Top Products
Proceed as follows:
d Connect the receiver (SCART socket TV) and the
television set (SCART socket) by means of a SCART
cable. If your television set is appropriately equipped,
this will be switched automatically to AV, and thus to
satellite reception, when the digital receiver is switched
on.
4.3.2 On RF cables*
If your television set is not equipped with a SCART socket,
the digital receiver must be connected to the antenna input of
the television set. In this case, sound can only be reproduced
in mono mode.
Proceed as follows:
e Use a suitable TV connection cable to connect the
receiver (RF output) to the antenna input of the tele-
vision set.
f The cable coming from the terrestrial antenna must be
connected to the Terrestrial antenna input of the
digital receiver.
You must now set the television set to the output channel of
the digital receiver. Select a free programme slot on the tele-
vision set, and tune it to Channel 38 (if necessary, refer to the
operating manual of the television set).
If you cannot obtain a clear picture on Channel 38, this chan-
nel or a neighbouring channel may already be tuned to a
channel being received via the antenna. You can confirm this
by briefly removing the antenna cable from the Terrestral
antenna input socket of the digital receiver. If you then
temporarily receive a better picture, you should select a diffe-
rent channel in the range of 21 to 69 for the digital receiver.
Setting the UHF output channel
To set an optimum UHF output channel, call up the menu
Audio/Video Settings, as described in 6.3., and select the
field UHF output channel. Then proceed as desribed
under 6.3.7.
4.4 Video cassette recorder (VCR)
g Connect the video recorder to the SCART socket
VCR. When set to Play, the video recorder will deliver
a switching signal to the digital receiver. The video
recorder signal will thus be provided automatically to
the TV set.
If your video recorder does not provide a switching sig-
nal, press the key EXTERN to set your digital recei-
ver to the external AV input. Press this key again to
return to normal operation.
12
* Only for receivers equipped with
this feature
bed_anl_DVB13 CIP_englisch_q5.qxd 08.09.03 11:14 Seite 12