Filter
Top Products
9.4 Current satellite list
The satellite positions stored in memory are shown in the
satellite list. Any positions not yet stored in memory are
marked with an “*”.
> To adjust the antenna dish to a position on the satellite
list, use the arrow keys to select the field Current
Satellite list.
> Confirm by pressing OK.
> Use the arrow keys up/down to select the desired
position.
> Confirm by pressing OK.
The antenna dish will now be rotated to the selected
position. The rotating procedure will be indicated by a
blinking display “rotating” in the menu.
9.4.1 Selecting a satellite position
To rotate the antenna to the position determined in the
satellite list, your digital receiver is equipped with the function
turn to Sat.
> Press the yellow function key Actions to open the
window displaying the available actions.
> Use the arrow keys up/down to select the line
turn to Sat.
> Confirm by pressing OK.
> Pressing the green key turn to Sat will rotate the
antenna to the selected satellite position.
9.5 Deleting a satellite position
To delete a satellite position from the satellite list, proceed as
follows:
> Use the arrow keys to mark the field Current
Satellite list.
> Press OK to open the current satellite list.
> Use the arrow keys up/down to select the satellite
you wish to delete.
> Confirm by pressing OK.
> Use the arrow keys to mark the field Sat delete.
> To delete the satellite selected, press OK and confirm
the message displayed by again pressing OK.
9.6 Reference position
When installing the external installation the motor must be set
to the reference position (0°). You can therefore rotate the
motor to this position (0°) at any time by means of the
function “Go to reference position”.
> Press the red function key Ref.pos to rotate the
antenna automatically to the reference position.
58
bed_anl_DVB13 CIP_englisch_q5.qxd 08.09.03 11:15 Seite 58