Filter
Top Products
9.3 Setting the satellite position
Proceed by sytematically working through Points 9.3.1 to
9.3.3 for each satellite position that is to be set. When pro-
gramming the satellite positions, we recommend that you
begin with the satellite in the most easterly position. Then
add each additional satellite in geographic order, working in a
westerly direction, until you have reached the most westerly
position.
Your digital receiver is pre-programmed at the factory for the
most popular satellite positions. In addition, you can configu-
re user-defined satellite positions for any orbital position of
your choice (User1 to User14).
9.3.1 Selecting a satellite position
9.3.1.1 Selecting a pre-programmed satellite
position
> To add a satellite position to the satellite list, use the
arrow keys to mark the field Sat new.
> Confirm by pressing OK.
A list will be displayed showing the available satellite
positions.
(Fig. 9-10)
> Now use the arrow keys up/down to mark a
satellite position that you wish to add to the satellite
list.
> Press OK to accept the selection.
If the Geo-Positioning (Point 9.2) function is On, the dish
antenna will now be rotated automatically to the programmed
satellite position. The rotation will be indicated by a blinking
display “turn”.
If the Geo-Positioning function is Off, you will have to
rotate the dish antenna manually (Point 9.3.2.2) to the
desired satellite position.
9.3.1.2 Setting a user-defined satellite position
> To add a user satellite position to the satellite list,use
the arrow keys to mark the field Sat new.
> Confirm by pressing OK.
A list will be displayed showing the available satellite
positions.
(Fig. 9-11)
> Now use the arrow keys up/down to mark a user
satellite position (User1 to User14).
> Press OK to display the menu used to set a test
transponder. In this menu, set the parameters for the
test transponder as well as for the LNC used as
described in Point 6.4.3.
55
(Fig. 9-11)
(Fig. 9-10)
bed_anl_DVB13 CIP_englisch_q5.qxd 08.09.03 11:15 Seite 55