Filter
Top Products
19
Installation
Figure 21 Example Of Sinking/Sourcing Connections
Any connections between the customer supplied interface (stepper controller, etc.)
and the command connector should be made through a shielded cable. The shield
of this cable should be connected to the customer interface ground (source end). If
no shield connection is available at the source end, then the shield connection on
the command connector (15 pin) may be used. Keep in mind that this shield
connection is connected internally to chassis ground of the drive.
The "STOP" I/O function must be held "Active" to prevent motion. if the
"Stop" I/O function is not held "Active", the operator must stop incoming
command voltage to avoid motion. Failure to follow proper safety procedures
can cause death or serious injury.