GE A016-1CG Cable Box User Manual


 
General A016-1CG-1.00-2
Full
23
Chapter 12: Configuring the
C3000/C0300 DPA A016_SP Table
This chapter describes entries the user must provide in the A016_SP table found in the
C3000/C0300 DPA configuration.
The A016_SP table provides information for setpoints, which are used by the C3000/C0300
DPA. The table contains one record for each setpoint to customize the usage of the point. The
fields contained in the table are described in the following table:
Table 13 A016_SP Table Fields
Field Range Description
System point If System point set to Analog
Output:
Any valid system Analog
Output point or Undefined (-1).
If System point set to Digital
Output:
Any valid system Digital Output
point or Undefined (-1).
If System point is set to Analog Output this field is the system analog
output point number (zero-based), which is used as the destination for a
LRU Setpoint. The high entry limit is confined to the highest system
analog output point configured in the system.
If options set to Digital Output this field is the point number of the first of
twelve contiguous system control output points, which are used as the
destination for a LRU Setpoint. The high entry limit is confined to 11 less
than the highest system control output point configured in the system.
Options
If System point set to Analog
Output:
AO: 2’s complement
AO: sign/magnitude
AO: unipolar
If System point set to Digital
Output:
DO: 2’s comp. D20 Latch
DO: sign/mag D20 Latch
DO: unipolar D20 Latch
DO: 2’s comp. Ext Latch
DO: sign/mag. Ext Latch
DO: unipolar Ext Latch
Specifies the setpoint output to either Analog Output or Digital Output’s
output in either 2’s complement, sign magnitude, or unipolar format.