Filter
Top Products
Unpacking and Assembly 1-5
Unpacking and
Assembly
This procedure assumes that the printer is in its final location.
See the Site Preparation Guide for moving and unpacking hints.
WARNING
The printer is too heavy to be lifted safely by one
person. At least two persons are required to lift the
printer.
WARNUNG
Der Drucker ist zu schwer für eine Person. Mindes-
tens 2 Personen sind erforderlich um den Drucker
anzuheben.
Note
If you will be installing a ColorSpan Print Server, set
it up now and power it on. This will allow the server
to perform its automatic one-time new system check
while you unpack and assemble the printer.
Unpacking 1. The printer is delivered to your site packed in one cardboard
box, attached to a plywood platform on two wooden pallets.
Examine the shipping packaging for shipping damage.
Report any damage or apparent rough handling immediately
to the shipper.
2. Remove the Unpacking and Assembly diagram, Watch Me
First CD-ROM, and other documents from the outside of the
box, and set them aside for reference.
You can use the Unpacking and Assembly diagram for refer-
ence during the unpacking and assembly process. The
Watch Me First CD-ROM contains useful “getting started”
information, including a demonstration of unpacking,
assembly, and setup.
3. Remove the bands that secure the box to the pallet and open
the top flaps of the box.
4. Carefully cut the corners of the outer box and remove it from
the pallet.
5. Remove the packing material from the printer.
6. Remove the stand crossbar, which is packed on top of the
printer.
7. Remove the ink tray boxes, stand leg boxes, and accessory
boxes, which are packed together in the center of the pallet.
8. Remove the cardboard shipping end caps from each end of
the printer.