Filter
Top Products
3-32 Cutting and Unloading Media
Cutting and
Unloading Media
1. Press the p key on the Front Page screen to advance the
printed portion of the media past the cutter anvil (on the
front edge of the platen).
2. From the front of the printer, place a utility knife blade in the
cutter channel and draw the cutter across the media.
Support the trailing edge of the media as you cut it from the
supply spool.
3. On the Front Page screen of the control panel, press the
Unload Media key.
4. The control panel prompts you to press B to unload media,
or n to cancel.
5. Press B to continue.
The control panel asks if you want to print the calculated
length of media remaining on the supply spool onto the
media for reference. When reloading the media later, the
control panel will prompt you to enter this value so it can
continue to track the amount of media remaining.
6. Press B to print the length remaining, or n to skip printing.
7. As desired, take the single print or takeup spool with printed
output to your finishing area, and re-load the takeup system.