Filter
Top Products
Installing the Server Blade and Options
Removing Hot-Plug SCSI Hard Drives
To remove hot-plug SCSI hard drives:
1. Back up all server blade data on the hard drive.
CAUTION: Before removing a hot-plug SCSI hard drive, use the LEDs to
determine the status of the drive. Refer to the “Hot-Plug SCSI Hard Drive LEDs”
section in Appendix E, “LEDs and Switches.”
CAUTION: If you are replacing a drive that is part of an array, refer to the
“Hot-Plug SCSI Hard Drive Replacement Guidelines” section in the HP ProLiant
Servers Troubleshooting Guide.
2. Press the port-colored ejector lever release button (1).
NOTE: Port-colored items indicate hot-plug components.
3. Pull the ejector lever open (2).
4. Remove the hard drive (3).
Figure 1-24: Removing a hot-plug SCSI hard drive
1-30 HP ProLiant BL40p Server Blade Setup and Installation Guide
HP CONFIDENTIAL
Writer: Amy Clute File Name: b-ch1 Installing the Server Blade and Options.doc
Codename: Black Ice Part Number: 307153-002 Last Saved On: 11/11/03 2:29 PM