Filter
Top Products
Installing the Server Blade and Options
4. If the server blade is not populating bays 1 through 4 (farthest left) or bays 5
through 8 (farthest right):
a. Use a Torx T-15 screwdriver to remove the 3 screws from the locking
handle (1).
b. Remove the locking handle from the back of the server blade (2).
NOTE: The locking handle keeps the server blade locked to the enclosure when it is installed
in either of the end bays. If you are installing the server blade in the middle of the enclosure,
the locking handle will not fit properly into the enclosure.
Figure 1-28: Removing the locking handle from the
server blade
HP ProLiant BL40p Server Blade Setup and Installation Guide 1-35
HP CONFIDENTIAL
Writer: Amy Clute File Name: b-ch1 Installing the Server Blade and Options.doc
Codename: Black Ice Part Number: 307153-002 Last Saved On: 11/11/03 2:29 PM