Filter
Top Products
Installing the Server Blade and Options
Installing Expansion Boards
The ProLiant BL40p server blade delivers fibre channel support for SAN
implementations and clustering capabilities. The server blade has two PCI-X slots for
redundant SAN connectivity and is optimized for HP StorageWorks. In addition, the
server blade is also compatible with certain third-party SAN products. Refer to the
contents included with the expansion board for cabling and SAN configuration
instructions. To install an expansion board into a PCI-X slot:
1. Remove the access panel. Refer to “Preparation Procedures” in this chapter.
2. Remove the expansion board blank corresponding to the PCI-X slot you are
populating by pressing down on the release lever (1), then pulling up (2).
3. Slide the expansion board blank out of the slot (3).
Figure 1-25: Removing expansion board blanks
HP ProLiant BL40p Server Blade Setup and Installation Guide 1-31
HP CONFIDENTIAL
Writer: Amy Clute File Name: b-ch1 Installing the Server Blade and Options.doc
Codename: Black Ice Part Number: 307153-002 Last Saved On: 11/11/03 2:29 PM