Filter
Top Products
Rev 1.00 6 Document 900.0399
09/05
Typical DVR Installation
Setting Unit for NTSC or PAL
Before turning on your DVR, set the switch (see Figure 2-1) to NTSC or PAL to match your
equipment. If your DVR is already powered, unplug the power cord from the wall outlet.
Wait a few seconds, set the switch (see Figure 2-1), and then re-apply power.
Note You cannot mix NTSC and PAL equipment. For example, do not connect
NTSC cameras when your DVR is set to PAL. Similarly, do not connect a
PAL camera and an NTSC monitor.
OUT1234
Four Audio
Inputs
Audio Line
Output
Four Sensor
Inputs
LAN for Remote
Access Software
Connection
1 Internal Alarm
Output Relay
CCTV Monitor
VGA Monitor
Four Video Inputs for Cameras
RS-232 for
Engineering Use
To 12 VDC
Adapter