Rev 2.00 7 Document 900.0399
03/06
Figure 2-1 NTSC/PAL Operation Switch
Connecting Peripheral Equipment
Figure 2-2 shows the rear panel connections. Refer to Table 2-1 to connect your network
system components.
Figure 2-2 Rear Panel Connections
Table 2-1 describes the rear panel connections as shown in Figure 2-2 from left to right.
Table 2-1 Rear Panel Connections
Connector Description
RS-422/485 Remote camera control (see Controlling a PTZ Camera, page 21).
ETHERNET Network the DVR using 10/100 MB Ethernet connector. Network to a PC
for remote monitoring and searching (see Setting Network Parameters,
page 21).
AUDIO IN Connect to a pre-amplified line level audio source, such as a microphone.
Note It is the user’s responsibility to determine if the local laws and
regulations permit recording audio.
AUDIO OUT Connect to an amplifier.
CH3 CH4
RS-232
VIDEO OUT VGA DC 12V
P
A
L
V
G
A
12
ON
PAL: Set to ON position
VIDEO IN
CH1 CH2
CH3 CH4
AUDIO IN
CH1 CH2 CH3 CH4
AUDI O O UTALARMSENSOR
RS-422/485
ETHERNET
RS-232
VIDEO OUT VGA DC 12V
P
A
L
V
G
A
CAUTION
WARN IN G
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
TO REDUCETHE RI SK OF FIRE OR ELECTRIC
SHOCK DO NOT EXPOSETHIS APPLIANCETO
RAIN OR MOISTURE
TO REDUCETHE RISK OF ELECTRIC SHOCK
NO U SER SERVICEABL EPARTS I NSIDE. REFE R
SERVICIN GTO QUALIF IED SERVICE PER SONNEL
TX+TX- RX+ RX-
1G G G G OUT234
12
ON
