Filter
Top Products
Rev 1.00 21 Document 900.0399
09/05
DHCP
Select DHCP to use the DHCP option when connecting the DVR to a network. An IP
address is automatically assigned by the DHCP server, which automatically assigns IP
addresses and other parameters to new devices. The assigned IP address and MAC
address are displayed when DHCP is selected.
If the network connection does not allow additional IP addresses, then an IP sharing device
will be needed. In this case, forwarding may be needed to allow for a network connection.
For more information on port forwarding, see the documentation for your IP sharing device,
or contact your network administrator.
ADSL
To use the ADSL option when connecting the DVR to a network, the following information is
required. See your network administrator if you do not have this information.
ID The user ID for the ADSL connection
Password The password for the ADSL connection
Your ADSL connection must have an RJ45 output to connect to the DVR.
When sharing the connection with other devices, an IP sharing device should be used. In
this case, select LAN as the NETWORK TYPE. You must also configure the IP sharing
device for port forwarding to allow for a network connection.
For more information on port forwarding, see the documentation for your IP sharing device,
or contact your network administrator.
Storage Setup
To assign how your DVR reacts when the hard drive is full, set the storage parameters in the
Storage Setup screen.
Figure 3-13 Storage Setup Screen
Table 3-9 describes the Storage field options.