Filter
Top Products
16
4 Press ENTER to select the correct code for your satellite receiver.
Manufacturer Code
GE 1
RCA 1, 8
PRIMESTAR
®
2
Sony 3
DISH Network 4
Toshiba 5
Panasonic 6
Hughes 7
none OFF
5 After you have selected, press MENU twice to exit the menus.
IMPORTANT
IMPORTANT
After you have connected the satellite receiver and set the brand code,
you need to see if your VCR can control your satellite receiver. To do
this, use CHANNEL or number buttons on the VCR remote to tune to a
satellite channel. If the satellite channels appear on your TV, then your
VCR can control your satellite receiver.
Adding and Deleting Channels
If necessary, you can manually add or delete channels after you have completed
the automatic channel memorizing. You cannot do this for channels coming from a
satellite receiver.
1 Make sure that video mute is ON. See page 47.
2 Set the VCR’s input to Tuner. To do this, press INPUT on the remote control
until a channel number appears on the screen or the front panel display.
3 Press MENU on the remote control. VCR Main Menu appears.
4 Press the ADJUST buttons on the remote control to select First Time Set-Up.
Press ENTER.
5 You will see the First Time Set-Up menu. Press the ADJUST buttons to
select Add/delete channels. Press ENTER.
IMPORTANT
IMPORTANT
If you are recording, playing back a tape, receiving a video signal from an
external input, or watching a satellite receiver channel, then Not available
will flash on-screen. To correct this, stop the tape or turn off the menus
and switch the VCR’s input to tuner.
6 You will see the screen for adding or deleting channels. Use the ADJUST
buttons to select the channel that you want to add or delete. Press ENTER
to add the channel; press CANCEL to delete it.
7 When you are finished adding or deleting channels, press MENU three times
to exit the menus.
IMPORTANT
IMPORTANT
If you use automatic memorizing again, you will lose all of the manual
changes you made. All of the channels you deleted will be added; all of
the channels you added will be deleted. If your cable box receives only
one or two digit channels, you cannot add a three-digit channel.
«Add/delete channels
Channel 39
Not in memory
∫πMENU to go back
∂ ππADJUST to select
≤¥≥πENTER to add
† ∑ ππADJUST to select
≠πππππCANCEL to delete
ƒFirst Time Set-Up
≈Set the clock
∆Memorize channels
«Add/delete channels
±Sat.receiver (OFF)
∫πMENU to go back
∂ ππADJUST to select
≤¥≥πENTER to enter
∑ ππADJUST to select
Setting Up Your VCR