52
Advanced Options
Using the remote control to operate your TV
The HS-U778 remote control can operate many of the frequently-used functions
of your TV. You only need one remote to operate both your VCR and TV.
The HS-U778 remote control is pre-set to operate Mitsubishi televisions, but it
can also operate TVs from other manufacturers. To set your remote control for
your particular brand of television, follow these instructions.
setting up your remote control to operate your TV
1 Turn off your TV.
2 On the HS-U778 remote control, set the VCR/TV slide switch to TV position.
3 While holding in SP/EP, press the brand code button listed that corresponds
to the brand of your TV.
4 Press TV POWER on the HS-U778 remote control. Once your TV has
turned on, your remote is set up to operate your brand of TV.
If your TV does not turn on, repeat step 3 using the next code listed for the brand
of your TV.
If none of the codes listed for the brand of your TV work, then repeat step 3
several times, using a different code button until one works. The possible code
buttons are: 0, 1-9, MUTE, VOLUME ª,º, CHANNELª,º and INPUT.
You do not need to perform this set-up again until you change the batteries, set
up your remote for another brand of television, or you get a new TV.
Once you have correctly set your remote control to operate your TV, you will be
able to use the TV POWER, CHANNEL, VOLUME, and number buttons to
operate your TV.
IMPORTANT
IMPORTANT
Because of variations among models, some or all buttons may not work, or
they may operate different functions than expected for your particular TV. If
this occurs, you may need to use your TV remote control.
Sometimes manufacturers will change the remote control codes for their
products, or they will use more than one code. If this is the case, your
remote may not be able to control your TV.
When you replace the batteries in your remote, the remote may return to
its initial setting (code button 1). Repeat the steps above to reset your
remote control. If you enter a new code, the previous code will be erased.
operating your TV with the HS-U778 remote control
1 Set the VCR/TV slide switch to TV position on the HS-U778 remote control
to tell the remote that you want to operate the TV.
2 Point the remote control towards the TV and press the desired buttons. To
once again control the VCR, set the VCR/TV slide switch to VCR position.
Advanced Features
Mitsubishi
Fisher
G.E.
Goldstar
Hitachi
JVC
Magnavox
NEC
Panasonic
Pioneer
Philips
Proscan
Quasar
RCA
Sanyo
Sharp
Sony
Toshiba
Zenith
1, 2, 3
0
VOLUME ª
2, 9
8
MUTE
4
2, 9
CHANNELª,º
6
4
VOLUME ª
CHANNELº
VOLUMEª
0
3, 5
VOLUMEº
7
INPUT
Brand of TV
Brand code
buttons
213
546
879
0
X
2
VCR
TV