Mitsubishi Electronics HS-U778 VCR User Manual


 
53
To program the remote control operational setting
The HS-U778 has two remote control operational settings, VCR-A and VCR-B.
These are available so you may separately control two Mitsubishi VCRs that are
placed close together. The VCR-A setting can be used to operate any other
Mitsubishi VCR introduced since 1986. Setting the HS-U778 to VCR-B will allow
the HS-U778 be operated without the VCR responding at the same time.
To program the HS-U778 and the remote to VCR-B
For VCR:
1 Make sure the HS-U778 is plugged in but turned off. On the VCR front panel,
press REC SPEED and REW at the same time. To confirm that the VCR
responds to VCR-B signals, b appears on the front panel display.
For remote:
2 On the remote, make sure the VCR/TV slide switch is in the VCR position,
then press VCR/TV and number “2” at the same time. The remote will now
send VCR-B signals.
When you wish to operate the other VCR
1 On the remote, with the VCR/TV slide switch in the VCR position, press
VCR/TV and the number “1” at the same time. The remote will now send
VCR-A signals.
To reprogram the HS-U778 to respond to VCR-A signals again
1 Make sure the HS-U778 is plugged in but turned off. On the VCR front panel,
press SP/EP and FF at the same time. To confirm that the VCR responds to
VCR-A signals, A appears on the front panel display.
IMPORTANT
IMPORTANT
Some other models of Mitsubishi VCRs can respond to VCR-B signals. If
your other VCR is one of these models, and you would like to program the
other VCR to respond to VCR-B signals, refer to the owner’s guide that
came with the other VCR.
Some of the buttons may not function or they may operate different
features than expected for the other VCR, particularly, those Mitsubishi
VCR’s that are more than 10 years old because Mitsubishi changes the
codes from time to time.
Child Lock
The child lock feature prevents others from using your VCR. To lock the VCR:
1 Press and hold down DISPLAY on the remote control for about 8 seconds.
The LOCK light on the front panel display will light up.
2 To cancel the child lock, press and hold down DISPLAY for about 8 seconds,
until the LOCK light on the front panel display goes out.
IMPORTANT
IMPORTANT
You can lock the VCR with the power off, even if the VCR is standing by for
a programmed recording. If you lock the VCR with no cassette in it, the
VCR will not accept a cassette. To unload the accidentally loaded tape while
the VCR is off and child lock is in use, press TIMER RESET on the rear panel
to cancel the child lock.
Advanced Features
LOCK light
LOCK
CH
M
S
H
L
R
REC
SP
VCR
FF
REW
SP/EP
REC SPEED
213
546
879
0
X
2
1
VCR/TV
213
546
879
0
X
2
2
VCR/TV