Filter
Top Products
6
IMPORTANT
IMPORTANT
Your TV Owner’s Guide may have additional
suggestions for audio video hookups.
To connect your VCR to a mono (non-stereo) TV,
connect only the white AUDIO OUT L of the
VCR and the white AUDIO INPUT of the TV.
Since the TV is not stereo, you cannot take
advantage of your VCR’s Hi-Fi stereo sound.
If you have an older TV without audio video
inputs, simply connect only the antenna or cable
as shown on the previous page.
Connections to TV with Audio Video Inputs
INPUT-1
INPUT-2
OUTPUT
MONITOR/TUNER
S-VIDEO
VIDEO
L (MONO) R
AUDIO
VIDEO S-VIDEO
OUT
AUDIORL
L
R
L
R
R
White
Red
Yellow
supplied audio/video cable
supplied S-video cable
White
Red
Yellow
TV Rear Panel
VCR Rear Panel
When you connect an S-video cable, please do
not connect a yellow video cable because it may
cause interference of the picture depending on
your TV.
Because you purchased a Hi-Fi VCR, you will want to
take advantage of its superior sound capability and
connect it to a stereo TV system with audio and video
inputs. This connection also helps maintain the best
picture quality.
1 Connect the red and white audio cable to AUDIO
OUT R (right) and AUDIO OUT L (left) on the
VCR. Connect the other end to the TV’s AUDIO
IN RIGHT and AUDIO IN LEFT. Match the colors
of the connectors to the cables.
2 Connect the S-video cable to S-VIDEO OUT on
VCR. Connect the other end to S-VIDEO INPUT
on the TV.
IMPORTANT
IMPORTANT
If your TV does not have S-video connections, use
standard yellow video cable in step 2.
3 Set the RF converter to OFF. See page 48 for
instructions on this setting, which can be done at a
later time.
Hooking Up Your VCR