Filter
Top Products
[SIGNAL LIST] menu
118 - ENGLISH
Settings
Select [SIGNAL LIST] from the main menu.
Refer to “Navigating through the menu”
(
page 61) for the operation of the menu
screen.
■
Registered signal status
z
A name can be set for each sub memory
(
page 120).
z
Memory number: A1 (1-2)
Sub memory number
When the address number (A1, A2, ... H7, H8)
is registered
Registering a signal to the list
After a new signal is input and the <MENU> button
on the remote control or the control panel is pressed,
the registration is completed and the [MAIN MENU]
screen is displayed.
Note
z
Up to 96 signals, including sub memories, can be
registered to the projector.
z
There are 12 pages (eight memories of A through
L, with eight memories possible on each page) for
memory numbers, and it is registered to the lowest
number that is available. If there is no available
memory number it will be overwritten from the
oldest signal.
z
The names to be registered are automatically
determined by the input signals and memory
numbers.
z
If a menu is being displayed, the new signals will
be registered at the instant they are input.
Renaming the registered data
1) Press
to select the signal for
which details are to be displayed.
2) Press the <ENTER> button.
z
The [REGISTERED SIGNAL STATUS] screen
is displayed.
z
The name, memory number, input terminal,
frequency, synchronization signal, etc., of the
input signal are displayed.
z
Press the <MENU> button to return to the
[REGISTERED SIGNAL LIST] screen.
3) Press the <ENTER> button.
z
The [REGISTERED SIGNAL SETUP] screen is
displayed.
4) Press
to select [SIGNAL NAME
CHANGE].
5) Press the <ENTER> button.
z
The [SIGNAL NAME CHANGE] screen is
displayed.
6) Press
to select the text, and
press the <ENTER> button to enter the
text.
7) After the name is changed, press
to select [OK], and press the
<ENTER> button.
z
The registration is completed and it will return
to the [REGISTERED SIGNAL SETUP] screen.
z
When pressing
to select [CANCEL]
and pressing the <ENTER> button, the
changed signal name will not be registered and
an automatically registered signal name will be
used.
Deleting the registered data
1) Press
to select the signal to
delete.
2) Press the <DEFAULT> button.
z
The [ENTRY SIGNAL DELETE] screen is
displayed.
z
To cancel the deletion, press the <MENU>
button to return to the [REGISTERED SIGNAL
LIST] screen.
3) Press the <ENTER> button.
z
The selected signal will be deleted.
Note
z
A signal can also be deleted from [ENTRY SIGNAL
DELETE] on the [REGISTERED SIGNAL SETUP]
screen.
[SIGNAL LIST] menu