Pelco DX4000 DVR User Manual


 
60 C2602M-C (3/07)
SYSTEM SETTINGS
Use the System tab to configure general system information for the DX4000. Some information can be reviewed on this tab but not changed.
Buzzer sound settings, passwords, disk write mode, and network connection and speed can be configured on the tab.
TIP: Refer to the System tab when you need to locate the software version number. The information on this tab is useful when troubleshooting
the system or upgrading to a newer version.
Figure 74. Configuring System Settings from the Remote Agent
To review system information
1. From the remote agent application main screen, click the Setup button if the Settings screen is not open. The Settings screen
appears and the Remote Agent tab is displayed.
2. Open the DVR System tab, and then click the System tab.
3. Review the following general system information:
S/W Version: This is the version number of the firmware installed on the DX4000.
H/W Version: This is the version number of the motherboard installed on the DX4000.
Video Signal Type: This is the type of video signal that you are recording from the cameras. Video signal types can be NTSC or PAL.
Disk Size: This is the size of the hard disk drive. If two hard disk drives are installed on the DX4000, this number is the size of the
primary hard disk drive.
Number of HDD: This is the number of hard disk drives installed on the DX4000. A maximum of two hard disk drives may be installed
on the unit.
IP Address: This is the IP address of the DX4000. Use this address when connecting to the DX4000 from the remote agent application
or the web client.
MAC Address: This is the MAC address of the DX4000. Use this address to connect to the DX4000 from the remote agent application
if your network uses a DDNS to derive IP addresses.
4. Click the OK button to close the screen.
To configure buzzer sounds
1. From the remote agent application main screen, click the Setup button if the Settings screen is not open. The Settings screen
appears and the Remote Agent tab is displayed.