Philips DMR-XS350EB DVD Recorder User Manual


 
108
RQT9431
Software Update
Software of this unit can be updated automatically by
following method.
From broadcasts
From Internet [network connection and setting is required.
(
106, 112)]
Update of the software is done when it is in standby mode.
Once the new software is found, it will start the download of
the software, and then update.
Download of the software will start automatically when the
power of this unit is turned in standby or when it is 3 a.m.
The time it takes to update depends on the connection.
For Broadcast: About 1 hour. (It may change depending on the
condition of the broadcast.)
For Internet: About 1 hour (It may take longer than specified
above to download because the download time differs depending
on the network environment. It is recommended to be used in a
broadband environment.)
If you do not want to perform the software update during the
standby mode, set “Software Update in Standby” in the Setup
menu to “Off”. (
104)
If a software update is available, a
notification is displayed
Update of the software will start when the power is turned
off.
To start downloading
Press [OK].
To ignore the new software
Press [EXIT].
The unit’s display during the update
“SW-DL” : Software is downloading. Download will stop
when the power is turned on, or the timer
recording starts.
“START”
: Update of the software will start once the
download is completed.
“UPD/
: Software is updating.
“FINISH” : Updated of the software has completed.
You cannot operate the unit until the update is complete.
Removing the AC mains lead while the update is in progress
may damage the unit.
Notes
If the timer recording is scheduled within the following time at the
start of the download, the download will not be executed.
For broadcast: Within 4 hours
For Internet: Within 1 hour
If downloading on this unit fails or this unit is not connected to
the Internet, then you can download the latest software from the
following website and burn it to a CD-R to update the software.
http://panasonic.net/support/