Pioneer HD-V9000 Home Theater Server User Manual


 
17
En
01
Chapter 1
Before you start
What’s in the box
•Remote control x 1
AA/R6 batteries x 2
•Power cord x 1
Rack mount brackets x 2
HDMI retaining cover x 1
Screws (black) x 8
•Warranty
Operating instructions (this booklet)
A large Philips screwdriver ( No. 2) is required to mount
the rack mount bracket. Please procure one.
Putting the batteries in the
remote control
1 Open the rear cover and insert the included
batteries (AA/R6 x 2).
Insert as indicated by the and marks in the battery
compartment.
Caution
Do not use any batteries other than the ones
specified. Also, do not use a new battery together with
an old one.
When loading the batteries into the remote control,
set them in the proper direction, as indicated by the
polarity marks ( and ).
Do not heat batteries, disassemble them, or put them
into flames or water.
Batteries may have different voltages, even if they look
similar. Do not use different kinds of batteries
together.
To prevent leakage of battery fluid, remove the
batteries if you do not plan to use the remote control
for a long period of time (1 month or more). If the fluid
should leak, wipe it carefully off the inside of the case,
then insert new batteries. If a battery should leak and
the fluid should get on your skin, flush it off with large
quantities of water.
When disposing of used batteries, please comply with
governmental regulations or environmental public
institution’s rules that apply in your country/area.
Do not use or store batteries in direct sunlight or
other excessively hot place, such as inside a car or
near a heater. This can cause batteries to leak,
overheat, explode or catch fire. It can also reduce the
life or performance of batteries.
Updating the firmware
When the software is updated, information concerning
this product may be published on the Pioneer website.
Check the update or service information concerning this
product on the site.
Website concerning this unit
In order to allow users to take maximum advantage of this
unit’s functions, a “Communications Interface User’s
Manual” and Windows application (HD PILOT) are
available on the Pioneer website. In addition to reading
this manual, please also visit the Pioneer website.
http://pioneer.jp/biz/