Filter
Top Products
43
En
05
Measuring the SD
memory card’s
transfer speed
The speed at which data on the SD memory card is read
into this unit can be measured.
Caution
• This SD memory card transfer speed is only a rough
measurement, and does not guarantee a playback bit
rate.
• To achieve stable playback operation, use SD memory
cards with a sufficiently high transfer speed with
respect to the playback bit rate.
1 Switch to the transfer speed measurement mode.
Press the SETUP button on the main unit’s front panel or
on the remote control for over one second.
2 Start the measurement.
Press the ENTER button. The following appears on the
main unit’s display:
When the measurement is completed, the results are
displayed in the order minimum value average value
maximum value.
• Press the ENTER button to restart the measurement.
• Press the RETURN button to cancel the transfer
speed measurement mode.
• When a display is connected to the VIDEO OUT
terminal, the same contents can be checked on the
display’s screen.
• If measurement is not possible, an error message
appears on the display. Check the SD memory card.
Ex.: When write-protected
WRITE PROTECT or FREE SPACE <100MB
• Several minutes are required to measure the transfer
speed.
• Use SD memory cards in FAT16, FAT32 or NTFS
format. The measurement is possible even if files are
stored on the SD memory card.
• Check the results of the measurement against
Guaranteed transfer speed under Cautions on using
SD memory cards on page 20.
S
ENTER tratto s .
DSpeedTest
Te i ng.st
x
ENTER:
est
Ret
xx/ xxx/xxx
Mb p s
x
Min Av
ax
eM
xx/ xxx/xxx
Mb p s
x
RETURN t:Exi
xx/ xxx/xxx
Mb p
s