Filter
Top Products
06
44
En
Chapter 6
Settings
Setting Menu
For details on operating the settings screen, see page 37.
Note
• Settings in bold are the factory defaults.
Video Settings
1 Select the desired picture quality settings.
Use the / buttons to select, then press the ENTER button. The screen switches to the selected setting.
• Standard (default) – Setting upon purchase. When this is selected, the detailed settings cannot be changed.
• Memory 1 to 3 – Video settings can be adjusted and saved here. Detailed Settings? is displayed. Select YES then
press the ENTER button. For a description of the setting items, see below.
Detailed settings for Memory 1, 2 and 3
Note
•When the DISPLAY button is pressed while the detailed settings are displayed, the display switches between one
item and all items each time the DISPLAY button is pressed. In the single item display mode, the settings can be
made while checking the picture being played.
• When the video output resolution is set to 1920 x 1080p, 3D or Flesh Tone can be selected at Noise Reduction,
but the noise reduction function does not actually work. The noise reduction function will work if the output
resolution is switched to something other than 1920 x 1080p.
Audio Settings
Digital audio output setting (Digital Audio Out)
Settings Description
Recall Settings Calls out the video settings set at Memory 1, 2 or 3.
Noise Reduction Reduces the noise of the brightness (Y) and color (C) signals.
MNR Mode
Reduces the mosquito noise (distortion generated in the contours of the picture during MPEG
compression) in the picture.
ACE Level Enhances the contrast in the dark areas.
Edge Level Adjusts the image’s contours.
ICR Mode Expresses a specific color (blue or green) more vividly.
Brightness
1
1. This setting does not affect the VIDEO OUT terminal’s output.
Adjusts the picture’s brightness.
Contrast
1
Adjusts the ratio of the brightness between the brightest and darkest parts of the picture.
Sharpness Adjusts the sharpness of the picture.
Hue
1
Adjusts the balance between the green and red.
Black Setup
Corrects for excessively strong black in the brightness signal. If the black is too weak due to the
combination with the connected display, select 7.5 IRE.
Settings Description
Off No audio signals are output from the DIGITAL AUDIO OUT or HDMI OUT terminals.
On Audio signals are output from the DIGITAL AUDIO OUT and HDMI OUT terminals.