Filter
Top Products
05
42
En
Switching the
resolution
Use the procedure below to switch the resolution of the
video signals output from COMPONENT VIDEO OUT
terminal, HDMI OUT terminal.
Caution
• With some devices (TVs, AV amplifiers, etc.), the
picture or sound may not be output properly if the
resolution is switched. If this happens, use the
OUTPUT RESOLUTION (+, –) buttons to set a
resolution at which the picture or sound is output
properly.
• When outputting with a resolution of 1920 x 1080p,
1920 x 1080i or 1280 x 720p from the HDMI OUT or
COMPONENT VIDEO OUT terminals, the signals
may be output with a ratio of 16:9, even when TV
Screen is set to 4:3 (page 45).
• The picture may not be displayed for several seconds
when the resolution is switched.
1 Press one of the OUTPUT RESOLUTION (+, –)
buttons.
The resolution switches each time the button is pressed.
• The current resolution setting can be checked on the
main unit display. Press the LCD button on the main
unit’s front panel to switch the resolution display.
• The resolution can also be switched at Scaler Setting
(page 45).
Displaying the
firmware version and
serial number
1 With playback stopped, press and hold the
DISPLAY button for over 1 second.
The display switches as shown below.
• The firmware version and serial number can also be
displayed by pressing the DISPLAY button on the
main unit’s front panel.
• To check on the display, see Information display
(Player Property) on page 51.
SEARCH
FRM
/TIME
REPEAT MEMORY RECALL
DISPLAY
PLAY
MODE
NAVI-
GATOR
SETUP RETURN
OUTPUT
RESOLUTION
+
-
STANDBY/ON
SEARCH
FRM
/TIME
REPEAT MEMORY RECALL
DISPLAY
PLAY
MODE
NAVI-
GATOR
SETUP RETURN
OUTPUT
RESOLUTION
+
-
STANDBY/ON
+
-
Ver. 01. 00
SN. JATW01234 5J P
Version number
Serial number Serial number – 12 digits are displayed