Filter
Top Products
2-6
English
5. Mount the HDD to the bracket-HDD with the SCREW-TAPTITE (BW, +, S, M3, L6, ZPC)
(4 spots) that was provided as an accessory. (The screws have to be tightened so that it
doesn’t vibrate loose.)
6. Re-mount the built-in HDD bracket-HDD to the place where it was separated from.
The work order for mounting the BRACKET-HDD is in reverse from when disassembling it.
Tighten the screw after the BRACKET-HDD’s mounting holes are perfectly aligned with four
mounting spots on the bottom.)
SCREWDRIVER
4. Remove the bracket-HDD from the product by lifting it upward from the product.
SHR-2040/2041/2042-ENG-1013 10/19/07 10:23 AM Page 2-6