Filter
Top Products
English
SHR-2040/2041/2042 USER’S MANUAL
5-33
Callback Settings
● The Callback function is used to forward a callback message to the IP where SmartViewer
is in action in case Alarm, Motion Detection, or Video Loss event occurs.
On/Off On
IP Address 192.168.001.010
Port(UDP) 7900
Retry 05
Transfer Alarm In Off
Transfer Motion Detection Off
Transfer Video Loss Off
Transfer System Log Off
Callback Settings
Cancel
OK
● On/Off : Off is default but you may choose On.
● IP Address : IP setting is available only when On is selected from On/off Setting.
Select the IP address of PC where SmartViewer is in action.
● Port(UDP) : You may choose one from 7900 to 7999 and the number changes by 1.
Selects the Port value for the Callback Connection menu from SmartViewer Setup.
● Retrial : You may choose one from 1 to 20 and the number changes by 1.
● Transfer Alarm In: Set it to On to display alarms on Smart Viewer.
● Transfer Motion Detection: Set it to On to display motion detection events on Smart
Viewer.
● Transfer Video Loss: Set it to On to display video loss events on Smart Viewer.
● Transfer System Log: Set it to On to display system logs such as critical system failures.
Caution
Caution
- Though Callback is set to ON, any Callback message will be created unless Alarm, Motion
Detection, and Video Loss are set by EventRecord.
- Unless the Callback button is clicked, SmartViewer does not receive any Callback message.
SHR-2040/2041/2042-ENG-1013 10/19/07 10:23 AM Page 5-33