Filter
Top Products
English
SHR-2040/2041/2042 USER’S MANUAL
5-27
6
Schedule
This setup selects a time to record automatically.
Selection by the day or by the time is available.
The default value is set to “Event Record”.
● Press “CH >” copies the value of Channel 1 to all the channels.
● The horizontal axis numbered from 0 to 23 represents the time value.
The vertical axis numbered from S to H represents the day value. (H : Holiday)
Selection by the day or by the time is available.
● Pressing “ALL” converts the overall setting of the selection window into
Continuous ➝ Event Record ➝ Schedule/Event Record.
● Record Schedule
Recording starts automatically on the preset time.
Recording follows the condition that set in 5-18.Record Mode.
☛ Refer to 7-2 Record Schedule.
● Event Recording
Recording starts automatically when an event (Alarm/Motion Detection/Video Loss)
occurs within a setup time.
Recording follows the condition that set in 5-20. Event Record Mode setup.
☛ Refer to 7-3 Event Recording.
● Schedule Record is yellow, Event Record is Blue, and Schedule/Event
Record is red.
● Schedule / Event Record
On occurrence of Event, Continuous Recording is replaced with Event Recording Mode.
● Holiday
If you press “Holiday”, a calendar pops up and you are able to designate holidays.
Move to a date and press “Enter” to complete designation.
Press “Enter” once more to cancel designation.
“H” at the bottom of the table means a holiday.
SHR-2040/2041/2042-ENG-1013 10/19/07 10:23 AM Page 5-27