Filter
Top Products
2-12
English
SHR-2042 HDD ADDITION
The user can add up to 2 HDDs to this product.
However, there are many factors that can cause electrical shock, accidents, and malfunctioning
of the device inside of the product. When the user does not correctly install or apply the proper
settings, the device may not recognize the HDD or the device will not run. Therefore, before
adding any HDDs, it is recommended that the user contacts a specialist where they purchased
the product.
[Caution when adding a HDD]
■ When adding HDDs, pay attention so that the cable doesn’t get caught between unsuitable places
or the cable’s insulation doesn’t come off. (This may cause a malfunction or fire.)
■ When adding HDDs, be careful not to receive any injury from the pointed edges inside the product.
■ Pay attention so as not to lose the disassembled screws or accessories.
If the screws or accessories are not put together, the product will either malfunction or will be inop
erable.
■ Check the compatibility list of HDDs before installing additional HDDs. The list of the compatible
devices with Samsung DVR can be obtained from your vendor.
■ If you contact the RTC battery while adding hard disks, the battery failure may happen. In this
case, you will encounter failures when setting the time and operating DVR.
■ If you don’t connect fan power cables after adding hard disks, the fan failure message appears on
the screen. This can cause operation failures because it raises the temperature inside your DVR.
[Setting the Jumper]
The jumper setting method is illustrated on the surface of the purchased HDD.
Using SAMSUNG hard disk, the jumper setting method is as follows:
• HDD jumper for Primary Master and Primary Slave.
• Jumper setting for Secondary Master (CD-RW) and Secondary Slave.
[How to Add a HDD]
1. To remove the product’s cover, take out the screws on the left and right sides (5 spots each)
and on the back (1 spot).
SHR-2040/2041/2042-ENG-1013 10/19/07 10:23 AM Page 2-12