Samsung SVR-1670 DVR User Manual


  Open as PDF
of 65
 
Digital Video Recorder User Guide
18
Digital Video Recorder User Guide
19
Chapter 3. Hardware Installation
3. 1 Installing the SVR-1670 in a Rack
3. 2 Working with Input/Output Terminals
TousetheSVR-1670safely,pleaseinstalltheSVRinarackusingtheenclosedrackmounts.Follow
theseinstructionstoinstalltheSVR-1670inarack.
1. Attach the enclosed rack mounts to the product.
2. Attach the enclosed rack mounts to the product.
This section discusses the proper handling of wires and cables when connecting sensors, relays and
otherdevicestotheSVR-1670.
You might need to prepare cables before connecting them to terminal blocks. Different wire gauges
are needed for stranded wire or solid wire. Prepare the end of the wire by removing the following
amounts of insulation:
· Stranded wire : Strip 1/3 ~ 1/2" (8 ~ 10mm) of insulation off the end of the wire and solder it together.
Use AWG 22 ~ 26 wire.
· Solid wire : Strip 1/3 ~ 1/2" (8 ~ 10mm) of insulation off the end of the wire. Use AWG 20 ~ 26.
Handling Cable Ends
Figure 3.2.1 Preparing Cables for Terminal Blocks
Figure 3.2.2 Inserting and Removing Wires
This section explains how to connect devices to the SVR-1670, within the following subsections:
•BasicConnectionDiagram
•ConnectingCameras
•ConnectingaMonitor
•ConnectingAudio
•ConnectingthePowerCable
3. 3 Basic Connections to the SVR-1670
Always turn off the SVR-1670 and disconnect the power cord from its power source before
you connect devices to the SVR-1670.
When inserting or removing a wire from a terminal block, do it while holding down the terminal block
with a screw driver.
Wire Insertion and Removal
Rack Mount
Rack
Rack Mount
 previous next