Filter
Top Products
Digital Video Recorder User Guide
56
Digital Video Recorder User Guide
57
DHCP
Dynamic Host Configuration Protocol (DHCP) manages host addresses on a
network. DHCP is used on a LAN with a DHCP server installed. If the LAN has a
DHCP server and you have enabled this DHCP option, the DHCP server will allocate
an IP address to the DVR.
IP Addr
IP Address is used for communication between the DVR and SVM-S1, and is also
used when Web Viewer accesses the DVR. It is available only when Net Mask and
Gateway are set.
Net Mask
Net Mask specifies a range of IP addresses and enables IP addresses in the range
to communicate. Net Mask should be allocated by a network administrator.
Gateway
Gateway must be specified to enable IP addresses to communicate and should be
allocated by a network administrator.
DNS1
DNS1 must be specified to register the DVR to DDNS Server(www.samsungipolis.
com) while DNS Address should be allocated by a network administrator.
Additional DNS Additional DNS is used to replace DNS1 when it is unstable or has a problem.
Port
Port is used to register to SWR, connect to SVM-S1, or connect to Web viewer. The
default port is 4000.
Bandwidth Limit
(Kbps)
Kbps sets the maximum transmission speed of data output from the DVR (the
data transmission capability of the DVR). This can be left blank. Ask your network
administrator to specify it when necessary.
Setting up for xDSL
ThissectiondiscussestheoptionsavailableifyourNetworkTypeisxDSL.
Figure 7.1.2 Network Submenu for the Type xDSL (on the Communication Menu)
Option Setting
Type
xDSL is the correct setting if the DVR is connected to a PPPoE-type xDSL line.
(If the xDSL line is not of the PPPoE type, you must select Ethernet.)
User ID Enter your User ID.
Password Enter your password.
Bandwidth Limit
(Kbps)
This sets the maximum transmission speed of data output from the DVR (the
data transmission capability of the DVR). This can be left blank. Ask your network
administrator to specify it when necessary.
Status
Displays the connection status of the DVR.
Port
Port is used to register to connect to SVM-S1 or to Web Viewer. The default port is
4000.
Chapter 7. Communication To/From the DVR