Filter
Top Products
-E7-
• Do not damage the power cord.
• When not in use, disconnect the power cord from the outlet.
Grasp the plug, not the cord, when disconnecting the unit.
• If water should enter the unit, electrical shock or a malfunction
may result. Use in an area where there is low humidity and
little dust.
• Do not disassemble or alter the unit in any way.
• Do not use the unit in areas where extremes in temperature
occur (below 40°F (5°C) or exceeding 95°F (35°C)), or where
it may be exposed to direct sunlight.
• Because of the DVD recorder extremely low noise and wide
dynamic range, there is a tendency to set the volume on the
amplifier higher than necessary. Doing so may produce an
excessively high output from the amplifier which can cause
damage to your speakers. Please be careful in this regard.
• Sudden changes in the surrounding temperature can cause
dew to form on the optical pickup lens inside the unit. Under
this condition the unit may be unable to operate properly. If
this should occur, remove the disc and allow the unit to adjust
to the surrounding temperature.
• When carrying the unit, be sure to remove a disc which
may be inside and turn the power off. Then unplug the
power cord from the AC outlet after 10 seconds. Carrying
the unit with a disc inside may damage the disc and/or
the unit.
• Do not install this equipment in a confined space, such as a
book case or built in cabinet.
FOR SAFE AND EFFICIENT OPERATION
Press [q OPEN/CLOSE] (or [OPEN/CLOSE] on the remote
control) when closing the disc tray. Do not push the disc tray.
CAUTION:
The unit must be operated in a horizontal position only.
The unit must be placed in a well ventilated area.
Do not place any object on the top of the unit.
Do not block ventilation holes.
The cabinet of the unit warms up when it is used for a long time,
however it is not a malfunction.
Need help? Call
1-800-813-3435
WHAT TO DO IF...
If the operation of the unit or display is not normal, even
though the appropriate buttons have been pressed.
1. Disconnect the power cord.
2. Connect the power cord again.
3. Operate the unit again.
Note:
If the unit still does not operate correctly, please contact your
nearest Sanyo Authorized Service Facility.
To reduce the volume temporarily (muting)
Press [MUTE] on the remote control. “MUTE” appears on the
TV screen.
To restore the previous volume setting, press [MUTE] again.
“MUTE OFF” appears briefly on the TV screen.