Filter
Top Products
-E8-
BASIC CONNECTION
Notes:
• Unpack the unit and insert the two AA size batteries in the
remote control (See page E6).
• Do not connect the power cord to a 120VAC 60Hz outlet
until all connections have been made.
Before Connection
This guide will help you to connect the unit.
Step 1: Connecting the Antenna Cable (See page E8.)
Step 2: Connecting the Video Cables (See page E11.)
Step 3: Connecting the Audio Cables (See page E12.)
Step 4: Connecting the Power Cord (See page E14.)
Step 1: Connecting the Antenna Cable
First, select one of the following antenna connections that best suit you.
Need help? Call
1-800-813-3435
If you use
Antenna only (no cable TV), or cable without cable box
Cable box with a few or many scrambled channels
Note to CATV system installer:
This reminder is provided to call the CATV system installer’s
attention to Section 820-40 of the NEC which provides guidelines
for proper grounding and, in particular, specifies that the cable
ground shall be connected to the grounding system of the
building, as close to the point of cable entry as practical.
Notes:
• If the antenna is a flat cable (300-ohm twin lead cable), use a
300-75 ohm matching transformer (not supplied) to connect
the antenna to the unit.
• If you use separate VHF and UHF antenna cables, use a
VHF/UHF band combiner (not supplied) to connect the
antenna to the unit.
• If you are not sure about the connection, please consult your
audio/video dealer.
See
Example: Basic Antenna/Cable connections (Page E9)
Example: Connecting a Cable Box (Page E10)
CAUTION:
Do not connect the antenna and VCR as shown below. Your
VCR doesn’t work.
VCR DVD recorder TV
VCRDVD recorder
TV