Filter
Top Products
CONNECTIONS
Connect the video camera and monitor TV as shown in the figure below.
NOTE: Before making the connections, make sure the devices are disconnected from the power outlet.
VIDEO
AC IN
AUDIO
MIC IN
S-VIDEO
IN OUT IN OUT IN OUT
ABRS485
RS232C
REMOTE
ADDRESS TERMINATE
EXT
TIMER IN
ALARM
RESET
IN
TRIGGER
SHOT REC
IN
TIMER
OUT
WARNING
OUT
TAPE
END OUT
NON REC
OUT
V.LOSS
OUT
SW
OUT
COM
COM COM
IN OUT
CLOCK SET
485
232
ON
OFF OFF
ON
PUSH
OPEN
IN OUT
SERIES
IN OUT
ALARM
IN OUT
EJECT
To remote control
(sold separately)
Video camera
(sold separately)
Monitor TV (sold separately)
Coaxial cable
(sold separately)
To
VIDEO IN
jack
To
VIDEO
OUT
jack
From an external
audio source
Power cord
To outlet
Power Cord Installation
1 Plug the supplied power cord firmly into the AC power
input AC IN ~ socket.
2 Insert the plug of this power cord into a outlet.
About the memory reset
If the VCR location is changed or to cancel previous
settings, please reset the memory as described below.
To reset the memory, press the ALL RESET button.
NOTE:
œ The time and date will be reset, and the quick method
security lock will be cancelled. The (SECURITY LOCK)
menu data cannot be reset.
NOTES:
œ For more details, please refer to the manuals
accompanying all other devices. If the connections are
not made properly, it may cause a fire or damage the
equipment.
œ You can use a VA-RMN01 Remote Control Unit (sold
separately) to control remotely the VCR.
œ The grounded power cord (3 pin plug) must be
connected to a grounded power outlet.
œ If there is no video signal when the power is turned on,
“NO VIDEO” will be displayed on-screen.
œ When both the VIDEO IN jack and S-VIDEO IN jack
are connected, the S-VIDEO IN jack will have priority.
œ When a multiplexer is used, a connection must be
made between the SW OUT terminal on the VCR and
the SW IN terminal on the multiplexer. If the connection
is not made, depending on the recording mode a part
of the image may not be recorded.
RD2QD/NA (DTL-4800 GB) Tue. Aug., 08/2000
10 English