Filter
Top Products
SETTING THE CASSETTE EJECT MODE
Cassette Eject Setup
When using 2 VCRs or more, the cassette tape of all the
VCRs or some of the VCRs can be ejected, if the EJECT
terminals on the VCRs are connected as indicated.
1 Press the MENU button to display the (MAIN MENU
1) menu.
2 Press the SHIFT ] button to select the “4. VARIOUS
SET 1” line, then press the MENU button.
ø
The (VARIOUS SET 1) menu appears.
@@@@<VARIOUS@SET@1>
*THREAD@CHECK@@@@Y
*REMOTE@@@@@@@@@@EJECT
*EXT@TIME@ADJ.@@@01:00
*TAPE@END@OUT@@@@PRE
*EJECT@SET
@@EJECT@MODE@@@@@EJECT1
@@OPERATION@@@@@@SLAVE
3 Press the SHIFT ] (or \) button, until the “EJECT
MODE” setting is flashing.
4 Press the DATA l (or j) button to set the desired
cassette eject mode.
EJECT1 . . . . The cassette is ejected only if the
VCR is not in recording mode.
EJECT2 . . . . The cassette is ejected only if the
VCR is in stop mode.
5 Press the SHIFT ] button, until the “OPERATION”
setting is flashing.
6 Press the DATA l (or j) button to set the desired
operation.
SLAVE . . . . . When the EJECT button is
pressed, the cassette tape of that
VCR only will be ejected.
MASTER . . . When the EJECT button is
pressed, the cassette tape of that
VCR and of any VCR connected
after it will be ejected.
7 Press the MENU EXIT button to save the settings.
NOTE:
œ The EJECT button will not be operative during
recording mode.
EJECT terminal connection
EJECT IN terminal
œ Depending on the (VARIOUS SET 1) menu
“EJECT MODE” setting (see “Cassette Eject
Setup”), the cassette loaded in the VCR is ejected
when there is an input at this terminal.
EJECT OUT terminal
œ When the EJECT button is pressed (if the VCR is
setup as “MASTER”, see step 6 under “Cassette
Eject Setup”) or when there is an input (trigger) at
the EJECT IN terminal, a signal is output at this
terminal, even if the security lock is set or if a
cassette is not loaded.
VCR No. 1
EJECT
IN OUT
VCR No. 2
EJECT
IN OUT
COM
COM
RD2QD/NA (DTL-4800 GB) Tue. Aug., 08/2000
English 45