Filter
Top Products
ALARM RECORDING
Pre Alarm Recording Setting
When there is an alarm trigger, the pictures accumulated
into the memory previous to the alarm trigger can be
recorded using the set recording speed mode (duration).
œ This will be activated by an alarm trigger if the “ALARM
RECORD MODE” is set to “Y1”, “Y3” or “Y4” and the
VCR is in stop mode.
1 Follow steps 1 and 2 under “Alarm Recording
Setting” on page 27.
@@@@@<RECORD@SET>
*ALARM@RECORD@MODE@@Y1
@@SPEED@@@@@@@@@@@@@N12
@@DURATION@@@@@@@@@@20S
*PRE@ALARM@RECORD@@@OFF
*POST@ALARM@RECORD@@OFF
@@DURATION@@@@@@@@@@20S
*TRIGGER@SHOT@REC@@@1
*TAPE@END@MODE@@@@@@REW
2 Press the SHIFT ] button, until the “PRE ALARM
RECORD” setting is flashing.
3 Press the DATA l (or j) button to select the
recording speed mode.
The recording duration will vary according to the
recording speed mode.
OFF . . . . . . . . . . . . . Prealarm recording is not
performed
Recording speed mode
Recording duration
(seconds)
F12 18
F24 36
F48 72
F72 108
F96 144
F120 180
F168 252
4 Press the MENU EXIT button to save the settings.
Post Alarm Recording Setting
After the alarm recording, you can set recording of the
picture to continue at a set recording speed mode, for
only a set duration.
1 Follow the steps 1 and 2 under “Alarm recording
Setting” on page 27.
2 Press the SHIFT ] button, until the “POST ALARM
RECORD” setting is flashing.
3 Press the DATA l (or j) button to select the
recording speed mode, then press the SHIFT ]
button.
OFF. . . . . . . . . . . . . . Postalarm recording is not
performed
4 Press the DATA l (or j) button to select the
postalarm duration. (20S, 40S, 1M, 2M, 3M, 4M, 5M).
20S-5M . . . . . . . . . . . Recording only for the
displayed duration
5 Press the MENU EXIT button to save the settings.
OFF F12 F24 F48 F72 F96 F120 F168
OFF F12 F24 F48 F72 F96 F120 F168
RD2QD/NA (DTL-4800 GB) Tue. Aug., 08/2000
30 English