Filter
Top Products
NORMAL RECORDING
Normal Recording
œ Turn the power on to all devices used.
œ Load a cassette tape with erasure-prevention tab.
NOTES:
œ If in the (VARIOUS SET 2) menu, TAPE IN MODE
is set to “REC”, recording will start after the tape
thread has been checked.
1 Press the REC/PLAY SPEED l (or j) button to set
the recording speed mode.
ø
The recording speed mode is displayed on the
digital display.
2 Press the REC button.
ø
The record indicator
“m”
light.
ø
Recording starts.
ø
If the tape end is reached while recording, “OFF”
is displayed on the digital display and the unit
goes into the mode set at the “TAPE END
MODE” line in the (RECORD SET) menu.
NOTES:
œ If the tape end is reached during recording, the
memory contents will be erased without being
recorded.
œ If in the (BUZZER SET) menu, TAPE END is set to
“Y”, the buzzer will be heard as long as “OFF” is
displayed on the digital display.
œ To cancel the “OFF” display, press the STOP,
EJECT, FF, REW or PLAY button.
3 To stop recording, press the STOP button.
ø
While the contents of the memory are recorded
onto the tape, “Ending” (Sweep out mode
display) flashes and
“m”
(Recording mode
display) is displayed on the digital display.
NOTES:
œ A tape recorded on this VCR cannot be played back on
other models of VCRs.
œ If you press on the REC button and the loaded
cassette has no erasure-prevention tab, the VCR will
eject the cassette.
œ This VCR will first store the recorded images in its
internal memory before recording them to the tape.
Due to this method of recording blocks of images, the
tape counter will not operate continuously. (The tape
counter will operate for about 9 seconds, then stop (the
duration until it starts again depends on the recording
speed mode setting) and start again.)
When recording is started, the counter will only start
operating after the memory is full.
Record Pause
Recording can be interrupted temporarily.
1 Press the STILL/PAUSE button during recording.
ø
The Pause/Still indicator
“N”
blinks.
NOTE:
œ The image appears on-screen but it is not recorded.
2 To resume recording, press the REC button, or press
the STILL/PAUSE button again.
Before starting
RD2QD/NA (DTL-4800 GB) Tue. Aug., 08/2000
English 21