Filter
Top Products
VIDEO CASSETTE TAPES
Correct tape thread check function
If the correct tape thread check function is on, after the
cassette tape is loaded, a mechanism will operate for
about 12 seconds to check that the tape has been
threaded (loaded) correctly and the cassette indicator “o”
will blink during that period. If the tape is not loaded
properly, the cassette will be ejected.
NOTES:
œ This function checks to make sure that the cassette
has been correctly loaded. It is recommended to use
this function to make sure the recordings are
conducted reliably.
œ If during the tape thread check operation, the REC,
PLAY, FF, REW or STOP button is pressed, the
command will only be executed after the tape thread
has been checked. Only the EJECT button will operate
while the tape thread is being checked.
œ If in the (VARIOUS SET 2) menu “TAPE IN MODE” is
set to “REC”, the recording indicator “m” will light while
the tape thread is checked. However, recording will
only start after the tape thread check is completed. To
cancel recording, press the STOP button.
1 Press the MENU button to display the (MAIN MENU
1) menu.
2 Press the SHIFT ] button to select the “4. VARIOUS
SET 1” line, then press the MENU button.
ø
The (VARIOUS SET 1) menu appears.
@@@@<VARIOUS@SET@1>
*THREAD@CHECK@@@@Y
*REMOTE@@@@@@@@@@EJECT
*EXT@TIME@ADJ.@@@01:00
*TAPE@END@OUT@@@@PRE
*EJECT@SET
@@EJECT@MODE@@@@@EJECT1
@@OPERATION@@@@@@SLAVE
3 Press the DATA l (or j) button to set the desired
mode.
Y . . . . . . . . . The correct tape thread check
function is on
N . . . . . . . . . The correct tape thread check
function is off
4 Press the MENU EXIT button to save the setting.
Setting the Action to Take When a
Cassette is Loaded
You can set the mode the VCR will go into when a
cassette is loaded.
1 Press the MENU button to display the (MAIN MENU
1) menu.
2 Press the SHIFT ] button to select the “5. VARIOUS
SET 2” line, then press the MENU button.
ø
The (VARIOUS SET 2) menu appears.
@@@@<VARIOUS@SET@2>
*TAPE@IN@MODE@@@@STOP
*VIDEO@LOSS@@@@@@Y
*REC@SPEED@@@@@@@N
*CLOG@DETECT.@@@@Y
*SERIES@REC@IN@@@N
*MX@@@@@@@@@@@@@@SANYO
3 Press the DATA l (or j) button to set the desired
mode.
STOP . . . . . . Stays in stop mode
REC . . . . . . . Goes into recording mode
4 Press the MENU EXIT button to save the setting.
RD2QD/NA (DTL-4800 GB) Tue. Aug., 08/2000
English 17