Filter
Top Products
NORMAL RECORDING
Setting the Mode at the End of the Tape
You can set the VCR mode when the tape reaches the
end during recording.
1 Press the MENU button to display the (MAIN MENU
1) menu.
2 Press the SHIFT ] button to select the “6. RECORD
SET” line, then press the MENU button.
ø
The (RECORD SET) menu appears.
@@@@@<RECORD@SET>
*ALARM@RECORD@MODE@@Y1
@@SPEED@@@@@@@@@@@@@N12
@@DURATION@@@@@@@@@@20S
*PRE@ALARM@RECORD@@@OFF
*POST@ALARM@RECORD@@OFF
@@DURATION@@@@@@@@@@20S
*TRIGGER@SHOT@REC@@@1
*TAPE@END@MODE@@@@@@REW
3 Press the SHIFT ] (or \) button, until the “TAPE
END MODE” setting is flashing.
œ If “TAPE END MODE” is set to “R1” or “R2” (see
step 4), “REPEAT RECORD” will be indicated
instead of “TAPE END MODE”.
4 Press the DATA l (or j) button to set the desired
mode.
Setting when not using Autorepeat recording
REW . . . . . . Rewinds the tape to the beginning,
then goes to stop mode
STOP . . . . . . Goes to stop mode
EJECT . . . . . The cassette is ejected
Setting when using Autorepeat recording
R1 . . . . . . . . Autorepeat recording mode is
automatically canceled if there was
an alarm trigger
R2 . . . . . . . . Autorepeat recording mode is
active even if there was an alarm
trigger
5 Press the MENU EXIT button to save the setting.
Action to Take when the Video Signal
Deteriorates
If there is no video signal during recording or when a
menu is not displayed (in stop, fast forward or rewind
modes), “VIDEO LOSS” can be displayed on-screen and
a signal (0 V) can be output at the V. LOSS OUT terminal.
If in the (BUZZER SET) menu, VIDEO LOSS is set to “Y”,
the buzzer will be heard. To stop the buzzer, press the
STOP button.
1 Press the MENU button to display the (MAIN MENU
1) menu.
2 Press the SHIFT ] button to select the “5. VARIOUS
SET 2” line, then press the MENU button.
ø
The (VARIOUS SET 2) menu appears.
@@@@<VARIOUS@SET@2>
*TAPE@IN@MODE@@@@STOP
*VIDEO@LOSS@@@@@@Y
*REC@SPEED@@@@@@@N
*CLOG@DETECT.@@@@Y
*SERIES@REC@IN@@@N
*MX@@@@@@@@@@@@@@SANYO
3 Press the SHIFT ] button, until the “VIDEO LOSS”
setting is flashing.
4 Press the DATA l (or j) button to set the desired
mode.
N. . . . . . . . . . The video loss warning is not active.
Y. . . . . . . . . . The video loss warning is active.
5 Press the MENU EXIT button to save the setting.
RD2QD/NA (DTL-4800 GB) Tue. Aug., 08/2000
24 English