Filter
Top Products
OUTPUT TERMINALS
REMOTE Jack
You can use a VA-RMN01 Remote Control Unit (sold
separately) to control remotely the VCR.
NOTE:
œ The functions not available on the VCR will not operate.
Remote control of the VCR is possible by connecting a
remote controller with a circuit such as indicated below, to
the REMOTE jack.
NOTES:
œ Use a 3.5 mm mini-jack type plug.
œ The connection should be done using a shielded cable
no more than 5 meters long.
œ The functions not available on the VCR will not operate.
Remote control setting
The remote control switch 7 can be set to either eject the
tape or access the menus.
1 Press the MENU button to display the (MAIN MENU
1) menu.
2 Press the SHIFT ] button to select the “4. VARIOUS
SET 1” line, then press the MENU button.
ø
The (VARIOUS SET 1) menu appears.
@@@@<VARIOUS@SET@1>
*THREAD@CHECK@@@@Y
*REMOTE@@@@@@@@@@EJECT
*EXT@TIME@ADJ.@@@01:00
*TAPE@END@OUT@@@@PRE
*EJECT@SET
@@EJECT@MODE@@@@@EJECT1
@@OPERATION@@@@@@SLAVE
3 Press the SHIFT ] button, until the “REMOTE”
setting is flashing.
4 Press the DATA l (or j) button to select the desired
switch mode.
EJECT . . . . . Switch 7 will eject the tape.
MENU . . . . . Switch 7 will display the menu.
5 Press the MENU EXIT button to save the setting.
NON REC OUT terminal
If during recording the VCR enters a mode other than
recording (i.e. recording pause, stop mode, etc.), a LOW
signal (0 V) is output. If recording is resumed, then a
HIGH signal (5 V) is output.
If in the (BUZZER SET) menu, NON REC is set to “Y”, a
buzzer will be heard while the VCR is in non recording
mode. The buzzer will stop if the STOP button is pressed
(the output signal will remain LOW (0 V)).
SW0: EJECT
R0 1.2K
Remote control circuit
The resistance tolerance is
2% or less.
SW2: STILL/PAUSE
SW3: REW
SW4: FF
SW5: PLAY
SW6: REC
SW7: EJECT (or MENU)
SW8: Not used
SW1: STOP
SW9: REC/PLAY SPEED, DATA j
SW10: REC/PLAY SPEED, DATA l
SW11: SHIFT ]
SW12: SHIFT «
R2 0.43K
R3 0.51K
R4 0.62K
R5 0.75K
R6 0.91K
R7 1.1K
R8 1.3K
R1 0.3K
R9 2.0K
R10 2.4K
R11 3.6K
R12 5.6K
RD2QD/NA (DTL-4800 GB) Tue. Aug., 08/2000
50 English