Filter
Top Products
OUTPUT TERMINALS
TAPE END OUT Terminal
œ During recording, when the end of the tape is reached
or when approximately 5% of the tape remains, the
output becomes 0V (Low).
œ To reset the output, press the STOP or EJECT button.
œ During autorepeat recording, when the end of the tape
is reached, the output becomes 0V (Low) for about 2
seconds only.
TAPE END OUT Terminal Output Setting
1 Press the MENU button to display the (MAIN MENU
1) menu.
2 Press the SHIFT ] button to select the “4. VARIOUS
SET 1” line, then press the MENU button.
ø
The (VARIOUS SET 1) menu appears.
@@@@<VARIOUS@SET@1>
*THREAD@CHECK@@@@Y
*REMOTE@@@@@@@@@@EJECT
*EXT@TIME@ADJ.@@@01:00
*TAPE@END@OUT@@@@PRE
*EJECT@SET
@@EJECT@MODE@@@@@EJECT1
@@OPERATION@@@@@@SLAVE
3 Press the SHIFT ] (or \) button, until the “TAPE
END OUT” setting is flashing.
4 Press the DATA l (or j) button to select the desired
output mode.
PRE . . . . . . . The output becomes 0 V (Low)
when approximately 5% of the tape
remains (if recording has been
started at the beginning of the tape)
and/or when the end of the tape is
reached (if recording has not been
started at the beginning of the tape).
END . . . . . . . The output becomes 0 V (Low)
when the tape reaches the end.
5 Press the MENU EXIT button to save the setting.
WARNING OUT Terminal
œ If the tape stops or other problem (the heads are dirty,
there is a problem with the battery or the cooling fan,
etc.) the output becomes 0V (Low).
œ To reset the output, press the STOP or ALL RESET
button or unplug the power cord then plug it back in.
NOTE:
œ If the output is 0V (Low) due to the clog detect function,
it can be reset by simply pressing the STOP button.
TIMER OUT Terminal
œ During timer recording DC 12 V (High) are output.
(During timer recording stand-by mode, the output is
0V (Low).)
COM Terminal
œ Common GND (ground) terminal when connecting
other terminals to external devices.
SW OUT Terminal
When recording, a pulse signal is output at the SW OUT
terminal.
This terminal is usually connected to the switch input (SW
IN) of devices like a camera switcher unit, or a quad
compressor.
End of the tape or approximately 5% of the tape remaining
5V (H)
0V (L)
(Output impedance: 5.7 kΩ)
Output reset
Tape movement stop
5V (H)
0V (L)
(Output impedance: 5.7 kΩ)
Output reset
Timer recording
12V (H)
0V (L)
(Output impedance: 5.7 kΩ)
5V (H)
0V (L)
(Output impedance: 5.7 kΩ)
FIELD: 16.7 msec.
RD2QD/NA (DTL-4800 GB) Tue. Aug., 08/2000
English 49